rns 510 coding vcds usb interface not found

New or reflashed RNS510 units may have a WSC 00000 stored which results in a 01042 - Control Module Not Coded Fault Code that will only clear of the WSC used for Coding the Module is NOT 00000. Make sure to enter a Plausible WorkShopCode (WSC) like 12345 on the Coding Screen.Due to different Control Modules and Equipment in the Car the actual Coding Table is not shown here but will automatically be used by the Long Coding Helper once you access the Function using VCDS.Update the Navigation System (J506 / #37) Coding.If the vehicle had a factory installed 1C-Position Sensing module it should be removed from the Gateway installation list and unplugged/removed from the vehicle.If the vehicle had a factory installed 0F - Radio (Digital) module it will need to be removed from the Gateway installation list and unplugged/removed from the vehicle.Address 56 - Radio should also be activated in case there was no Radio installed prior to the Retrofit. Register the newly added 37 - Navigation Control Module, in case you had a Navigation System installed before the Retrofit this step may not be necessary.Update the Installation List in the Gateway (J533 / #19).The following Activations are necessary to ensure that the newly fitted parts are properly recognized and are ready to use. This might be classed as a safety feature, so might be why I cannot find the code. You can un-mute via the display so must be a default setting. What I cannot find is how to stop the radio from muting as soon as I put into reserve.

I found the settings in a ross tech how to: Search rosstech and RNS510 retrofit. To get the satnav on the dash display I had to add it via VCDS to the gateway list. Hi, not a Yeti, but I retrofitted the rns510 to my cali.

Rns 510 coding vcds usb interface not found